- #Spi programmer serial
- #Spi programmer windows 10
- #Spi programmer software
- #Spi programmer Bluetooth
- #Spi programmer series
The Serial Peripheral Interface (SPI) and Inter-Integrated Circuit (I 2C) Programmer modules offer fast programming of SPI devices and convenient programming of I 2C memory devices by controlling the serial bus signals directly through dedicated SPI and I 2C interface available on supported Corelis boundary-scan controllers. Concurrent programming for up to four boards on supported Corelis JTAG controllers is included for increased throughput. The JTAG programmer can also program CPLDs, FPGAs, and other JTAG in-system programmable devices.
#Spi programmer software
Boundary-scan Flash programming files are generated by the ScanExpress Flash Generator™ software (sold separately). The JTAG Programmer module is a flexible JTAG/boundary-scan programmer capable of programming Flash memory and serial EEPROM devices connected to boundary-scan components. See Ordering Information for module licensing options. ScanExpress JTAG Programmer features four unique programming modules: JTAG Programmer, SPI Programmer, I 2C Programmer, and Target Assisted Flash (TAF) Programmer.
#Spi programmer windows 10
Use the CSR USB-SPI Programmer with a ComputerĪfter being plugged into the USB port of the PC, this product could be found in the Device Manager. SPI electrical level can be 1.8V or 3.3V.(Switch to the right or the left)Ģ. 3V3 pin can output a current of 300 mA, however, when the programmer works at 1.8V (switch to the right), the 3V3 pin should not be used to output power.Ĭ.
#Spi programmer Bluetooth
A one-to-one correspondent with the SPI interface of the CSR Bluetooth chipset.ī. CSB, MOSI, MISO, CLK are SPI programmer interfaces.
#Spi programmer series
It’s a good choice to those computers which do not support parallel port.ĬSR USB-SPI Programmer Supports All CSR Chipset Series, for instance:īC3 Series (e.g. CSR USB-SPI Programmer adopts a true USB port, its communicating speed is much higher than a regular parallel port. BlueFlash, PSTOOL, BlueTest3, BlueLab, etc). Feasycom has a CSR USB-SPI programmer with a 6-pin port (CSB, MOSI, MISO, CLK, 3V3, GND), with these 6 pins connected to the module, customers can develop with the module by CSR’s software development kits (e.g. At first, they found a programmer with an RS232 port which is not supported by the Feasycom’s CSR module. Recently, one customer has a requirement about the CSR USB-SPI programmer for development purposes.